-1
I think this additional language adds no useful content to the
specification. All it says is: WSDL has binding problems and they are
WSDL's problems not ours.
Since we only deal with abstract port types and abstract message types,
it is absolutely clear already that it is someone else's responsibility
to "make things right" from the wire layer to the abstract layer.
Satish
-----Original Message-----
From: Yaron Y. Goland [mailto:]
Sent: Friday, February 11, 2005 12:47 PM
To: wsbpeltc
Subject: [wsbpel] Issue 154 - Proposal For Vote
Issue 154 - doc/lit & multiple body parts
Proposal: To put in language that makes explicit what is currently
implicit in the BPEL spec, that it is the binding layer's job to
decompose the physical message into the portType definition.
Rationale: One of the more basic flaws in spec writing is to make
implicit assumptions. By doing so spec implementers are always left in
the dark because they may not share the same implicit assumptions as the
spec authors. The fix is to make the implicit assumption explicit which
is what this proposal does. Note, however, that this proposal causes no
normative changes to BPEL's current behavior, it just makes what was
implicit, explicit.
Changes Required:
Section 3 -
Insert new paragraph after the paragraph that begins "While WS-BPEL
attempts to provide as much compatibility with WSDL 1.1 as possible..."
BPEL assumes that the WSDL binding layer is able to decompose incoming
messages into the parts specified by the WSDL message definition.
However it is know that certain combinations of message definitions and
bindings, including ones defined in the WSDL standard itself, cannot be
decomposed in any standard way. For example, a multi-part WSDL message
where one of the parts is a complexType and a doc/lit SOAP transport can
create ambiguous situations. The BPEL specification assumes that these
ambiguities will be dealt with at the binding layer, perhaps by
forbidding ambiguous message definitions, and are therefore out of scope
of BPEL.
To unsubscribe from this mailing list (and be removed from the roster of
the OASIS TC), go to
http://www.oasis-open.org/apps/org/workgroup/wsbpel/members/leave_workgr
oup.php.
