At 14:26 07/10/2003 -0400, Jeff Beal wrote:
>Numbering happens in the 'label.markup' mode and the templates that control
>that are contained in common/labels.xsl. The template matching 'section'
>can be modified as follows:
>
>(at end of template)
>
> <xsl:choose>
> <xsl:when test="@label">
> <xsl:value-of select="@label"/>
> </xsl:when>
> <xsl:when test="$label != 0">
> <!-- add appropriate 'from' attribute to number this from the book -->
> <xsl:number count="section" from="book"/>
> </xsl:when>
> </xsl:choose>
>
>You will probably have to dig through some of the other code in this
>template to be sure that everything is taken care of, but this should get
>you started.
That did it Jeff.
Hardly customis(z)ation, but it'll do for this little project.
Thanks again.
Such a dirty job, I'm learning all sorts about docbook :-)
I've just had an abject lesson in table markup!
why is it
entry namest="c2" nameend="c3" colsep="0" align="center">
name st (art) yet
name end ??
My typo cost me lots of time :-) then I validated....
except I couldn't, I've added linebreaks from the html ns.
Unless you know better?
I've 5 lines of copyright stuff
centred, close gaps between lines,
c Copyright 2004
Council of xxxx cccccccc
Not to be reproduced ....../.
whatsoever without permissions
all rights reserved.
I had a real markup problem with that.
Thanks anyway Jeff.
Back to the typing.
regards DaveP
